Search Knowledge Base Articles
(How to) clear RH-M1 CMOS
Unit not Booting - Blinking Blue Light
Take off the back panel that has the camera on it. (There are two different size screws. Make sure the screws go back into the correct place or you will damage the unit)
Take the screw driver and run it against the RTC circuit shorting pad. You should hear a clicking noise.
With the CMOS cleared, see if the unit will boot.
Please update your BIOS to the latest version which can be found at: http://patrolpc.com/downloads/
Take off the back panel that has the camera on it. (There are two different size screws. Make sure the screws go back into the correct place or you will damage the unit)
Take the screw driver and run it against the RTC circuit shorting pad. You should hear a clicking noise.
With the CMOS cleared, see if the unit will boot.
Please update your BIOS to the latest version which can be found at: http://patrolpc.com/downloads/
Did you find this article useful?
Related Articles
-
Ent Mobile (CAD) not connecting to GPS
I actually figured it out….so theres a setting in the config fil...
-
UPS Install Path
\\PPCSERVER-ROLES\Users\Public\UPS\WSTD\Remote\Install\Disk1...
-
F5 - how to boot to a thumb drive
1. &n...
-
(How to) 2D Scanner Reset Defaults
Resetting Factory DefaultsThis selection erases all your settings and res...
-
(How to) backup and deploy images via Redo Backup
Backup and Deploy Images via Redo Backup Download Redo software fr...